|
The M30 Autodialer and its predecessors have been used in the Water market since 1958, providing alarm notification and monitoring of remote and unattended facilities. While initially providing simple alarm notification for loss of power and high level, many facilities have added diagnostic information to reduce the number of site visits and increase time between equipment failures.
Below are some examples of some things the M30 Autodialer is used to monitor;
- Water tanks
- Wells
- Water distribution
- Water Level (High or Low)
- Levels drop or rise to quickly
- Automatic reporting of levels
- Pump run times, number of cycles and time when pumps start and stop
- Motor starter failures.
- Log water flows
- Power Lose on single or three phase motors
- Line pressure (High \ Low \ Distribution)
- Chlorine Levels
The M30 Autodialer allows you to;
- Monitor remote stations or pumps from anywhere in the world
- Get messages via your land line, mobile phone, pager, text message
- Know about a small problem before it becomes a failure.
- Monitor 1 to 56 digital or analogue inputs.
- Call-in for status
|
